The
extremely easy to use Lipovisor™ displays with
extreme precision on its own colour monitor, the thickness
of the fat layer, the type of fat present and the precise
location of the fat to be removed.
In other words, the Lipovisor™ allows the layer
of fat tissue that is being removed to be perfectly
controlled before, during and after the liposuction
or liposculpting procedure. This allows the operation
to be performed with extreme precision and in high
definition (HDL - High Definition Liposuction).
The Lipovisor™ can be used successfully by
all plastic and cosmetic surgeons to perform any liposuction
or liposculpting procedure with a higher level of
accuracy.
Liposuction should, in fact, not just be used for
the removal of fat but, more importantly the re-shaping
and contouring of the body according to the many different
directions and planes.
This is very important if you consider that the fat
cells, once removed, will not form again. A thorough
pre-operative exam of each patient is fundamental.
The distribution of excess fat tissue will change
depending on if the patient is in a standing or lying
position. This is when the surgeon’s abilities
and skills of observation become a determining factor
during the operation.
In similar operations it is essential to maintain
a determined amount of fat tissue in order to shape
the contours of the body, while on the other hand
an inadequate accumulation or lack of fat caused by
a negligent operator will result in noticeable waves
in the skin along with aesthetically unpleasant blemishes.
In this last case it would be necessary to proceed
with a second operation in order to remove the excess
fat deposits, clearly causing the patient discomfort
and the surgeon embarrassment.
Even excess removal of the fat deposits would cause
notable discomfort to the patient, as it would cause
permanent lumps and dents in the skin and would be
difficult to cover up permanently.
Typically, in this type of operation, surgeons rely
solely on their own manual sensitivity, which results
in clear difficulties in determining with absolute
precision the quantity of fat to remove, and more
importantly what not to remove.
The purpose of computerized high definition liposculpting
(HDL - High Definition Liposuction) is to avoid the
inconveniences discussed above by scanning the fat
tissue before, during and after the procedure.
The Lipovisor™ is a device that can displays
the exact quantity and distribution of fat deposits
in the body.
Computerized high definition liposculpting with the
use of the Lipovisor™ is simple and immediate.
It allows the distribution and quantity of the fat
tissue to be measured accurately and then provides
a graphical representation of it that is as close
to reality as possible. |